メインコンテンツにスキップ

はじめに

This guide will show you how to disassemble the back and side panel of the printer.

パーツ

パーツは指定されていません。

  1. Remove the following two Phillips screws: Two 7.85 mm Phillips #1 screws
    • Remove the following two Phillips screws:

    • Two 7.85 mm Phillips #1 screws

  2. Pull the back cover off by lifting up on the cover.
    • Pull the back cover off by lifting up on the cover.

    • You may need to pull firmly as it requires quite a bit of force.

  3. Open the front tray.
    • Open the front tray.

  4. Lift the scanner compartment.
    • Lift the scanner compartment.

  5. After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.
    • After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.

  6. Push the blue lever back while twisting it clockwise in order to remove the lever from its slot. After removing the lever, close the scanner compartment and the scanner cover.
    • Push the blue lever back while twisting it clockwise in order to remove the lever from its slot.

    • After removing the lever, close the scanner compartment and the scanner cover.

  7. Use the plastic opening tool to pry open the side cover. Use the plastic opening tool to pry open the side cover.
    • Use the plastic opening tool to pry open the side cover.

  8. Flip the printer so that you are facing the underside. Use the plastic opening tool to remove the corner of the side panel from the pin.
    • Flip the printer so that you are facing the underside.

    • Use the plastic opening tool to remove the corner of the side panel from the pin.

    • Plastic pin.

  9. Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer. Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.
    • Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.

まとめ

To reassemble your device, follow these instructions in reverse order.

5 の人々がこのガイドを完成させました。

Kevin Cole

メンバー登録日: 2013年01月17日

98 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 19-41, Regan Winter 2013 Cal Poly, Team 19-41, Regan Winter 2013人のメンバー

CPSU-REGAN-W13S19G41

4 メンバー

6のガイドは作成済み

コメント1件

コメントを追加する

統計データを表示:

過去 24時間: 5

過去 7 日: 14

過去 30 日: 112

今までの合計 14,484