Disassembling Canon EOS Digital Rebel XT (350D) Cover

はじめに

In this guide, you will remove the camera’s covering. Please note that this involves thoroughly disassembling the entire camera and should only be done if you need direct access to the camera membrane.

必要な工具と部品

手順1 Cover

Disassembling Canon EOS Digital Rebel XT (350D) Cover, Cover: 手順 1、 1の画像 1

Make sure to remove the battery to avoid any harm to yourself or the camera.
At the bottom of the camera, there are 5 screws. Use the Phillips #00 head to remove all 5 screws

編集

手順2

Use your thumbs and push up to gently remove the eye lens cover.

編集

手順3

Remove the 2 screws under the eye lens cover using the Phillips #00 head.

編集

手順4

Turn the camera to the left side and use Phillips #00 head to unscrew the the top and bottom screws of the panel.

編集

手順5

There is another screw on top of the panel on the left side of the camera. Use Phillips #00 head to remove it.

編集

手順6

Turn on the camera on the right side and use Phillips #00 head to remove the 2 screws parallel from one another.

編集

手順7

There is another screw on top of the panel on the right side of the camera. Use Phillips #00 head to remove it.

編集

手順8

Open the memory card port and take out the CompactFlash from the inside. Upon removing the flash remove the 3 screws with a Phillips #00 head.

編集

手順9

Carefully remove the back camera cover with your fingers.

編集

手順10

Gently remove the orange ribbon cable from the motherboard using your hands or tweezers. Carefully detach the orange ribbon cable connector from the body of the camera.

編集

手順11

Looking at the front side of the camera, remove the 2 screws below the Canon flash with a Phillips #00 head.
Make sure to avoid touching the lens itself directly to prevent scratches or dirt.

編集