メインコンテンツにスキップ

はじめに

If the input/output port is broken this guide will teach you how to remove the broken component for replacement.

パーツ

パーツは指定されていません。

  1. Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks. Remove the four 8mm Phillips #0 screws located on the back panel.
    • Unplug the device from its AC power adapter; unplug anything connected to the input/output jacks.

    • Remove the four 8mm Phillips #0 screws located on the back panel.

  2. Remove the back panel to expose the motherboard. Remove the back panel to expose the motherboard.
    • Remove the back panel to expose the motherboard.

  3. Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.
    • Remove the two 11mm #0 Phillips screws located at the bottom of the motherboard.

  4. Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.
    • Lift the indented end of the motherboard opposite the input/output jacks. Then, pull away from the input/output jacks to slide the motherboard out of the casing.

  5. Desolder the back of the motherboard where the damaged input/output port is located. Desolder the back of the motherboard where the damaged input/output port is located.
    • Desolder the back of the motherboard where the damaged input/output port is located.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Elijah Smith

メンバー登録日: 2018年09月10日

726 ポイント

6のガイドは作成済み

チーム

Appalachian State University, Team S2-G2, Menagarishvili Fall 2018 Appalachian State University, Team S2-G2, Menagarishvili Fall 2018人のメンバー

APSU-MENAGARISHVILI-F18S2G2

3 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 3

今までの合計 206