DigiLand DL8006 Motherboard Replacement

はじめに

This guide will demonstrate how to replace to the DigiLand DL8006's motherboard. If your device is is experiencing frequent freezes and system lockups, and you have determined that it is not the fault of the RAM, power supply, or CPU, you may need to replace your motherboard. Make sure that you save your data on a separate device, as all the locally stored date will be removed when your motherboard is replaced.

必要な工具と部品

手順1 Motherboard

DigiLand DL8006 Motherboard Replacement, Motherboard: 手順 1、 2の画像 1

DigiLand DL8006 Motherboard Replacement, Motherboard: 手順 1、 2の画像 2

Remove the backing of the tablet to reveal the internal components using a plastic opening tool.

編集

手順2

Peel back the metallic tape connecting the motherboard to the tablet body with your fingers.

編集

手順3

DigiLand DL8006 Motherboard Replacement: 手順 3、 3の画像 3

Remove the battery plug from the motherboard.
Fingers may be used to gently wiggle the connector out if it becomes stuck.
If battery wires are under the ribbon, Do Step #4 first.

編集

手順4

Opening the locking tab of the ZIF connector and carefully remove the upper section of the ribbon cable from the motherboard using tweezers.

編集

手順5

Disconnect the three remaining ribbons by opening the locking tabs of the ZIF connectors and gently pulling the cables out.
Use tweezers to manipulate the connectors and ribbons to prevent damage.

編集

手順6

DigiLand DL8006 Motherboard Replacement: 手順 6、 3の画像 3

Remove the 3 mounting screws from the motherboard with a Phillips #0 screwdriver.
One of the screws is located under a ribbon. You will need to gently peel back the cable to access it (see image 3).

編集