はじめに

Before the majority of components can be accessed to be replaced, the back panel will need to come off.

  1. Turn the laptop upside down.
    • Turn the laptop upside down.

    • Make sure the laptop is turned off.

    • Using the T5 Torx Screwdriver, remove the ten 3 mm long screws from the perimeter of the back of the laptop.

  2. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  3. Open up the information panel door (on the middle of the back side). While holding the door open, use the Phillips #00 Screwdriver to remove the two 10 mm long screws.
    • Open up the information panel door (on the middle of the back side).

    • While holding the door open, use the Phillips #00 Screwdriver to remove the two 10 mm long screws.

  4. Carefully lift 2  corners of the back panel upwards, releasing the whole panel. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck. Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.
    • Carefully lift 2 corners of the back panel upwards, releasing the whole panel.

    • Do not force the panel off. If it does not come off easily, try using a plastic spudger where it is stuck.

まとめ

To reassemble your device, follow these instructions in reverse order.

Brandon Schmidt

メンバー登録日: 2018年10月04日

534 ポイント

3のガイドは作成済み

チーム

UW Stout, Team S6-G1, Ogden Fall 2018 UW Stout, Team S6-G1, Ogden Fall 2018人のメンバー

UWSTOUT-OGDEN-F18S6G1

4 メンバー

5のガイドは作成済み

統計データを表示:

過去 24時間: 8

過去 7 日: 54

過去 30 日: 250

今までの合計 806