Dell XPS 13 9365 2-in-1 Display Assembly Replacement

はじめに

Use this guide to remove or replace this display assembly (screen) on your Dell XPS 13 9365 2-in-1 laptop. The display assembly on this laptop refers to the entire upper portion of the laptop, which houses the screen display.

必要な工具と部品

手順1 Battery

Dell XPS 13 9365 2-in-1 Display Assembly Replacement, Battery: 手順 1、 1の画像 1

Use a Torx T4 screwdriver to remove the eight screws (M2x3) that secure the base cover to the palm-rest assembly.

編集

手順2

Use your fingertips to lift the system badge open and reveal the single case screw.
Use a Phillips #000 screwdriver to remove the screw (M1.6x4) that secures the base cover to the palm-rest assembly.

編集

手順3

Starting from the front corner of the computer, pry up the base cover using a spudger and lift the base cover off the palm-rest assembly.

編集

手順4

Disconnect the battery cable from the system board.

編集

手順5

Use a Phillips #000 screwdriver to remove the two screws (M1.6x4) that secure the battery to the palm-rest assembly.

編集

手順6

Use a Phillips #000 screwdriver to remove the six screws (M2x3) that secure the battery to the palm-rest assembly.

編集

手順7

Lift the battery off the palm-rest assembly.

編集

手順8 Display Assembly

Dell XPS 13 9365 2-in-1 Display Assembly Replacement, Display Assembly: 手順 8、 1の画像 1

Use a Phillips #000 screwdriver to remove the screw (M1.6x2.5) that secures the wireless-card bracket to the motherboard.

編集

手順9

Lift the wireless-card bracket off the wireless card.

編集

手順10

Use a pair of nylon tipped tweezers to gently disconnect the antenna cables from the wireless card.

編集

手順11

Peel off the tape that secures the display cable to the M.2 solid-state drive heatsink.

編集

手順12

Use a Phillips #000 screwdriver to remove the two screws (M1.6x2.5) that secure the display cable bracket to the motherboard.
Lift the display cable bracket off the display cable.

編集

手順13

Use the pull tab to disconnect the display cable from the motherboard.

編集

手順14

Disconnect the touch-screen cable from the system board (labeled "TS").

編集

手順15

Disconnect the camera cable from the system board.

編集

手順16

Dell XPS 13 9365 2-in-1 Display Assembly Replacement: 手順 16、 3の画像 3

Open the palm-rest assembly fully and place the display assembly and palm-rest assembly face down.
Make sure that your surface is flat and free of objects when you lay the laptop face down.
Use a Phillips #000 screwdriver to remove the six screws (M2.5x3.5) that secure the display hinges to the palm-rest assembly. There are three on each side.