メインコンテンツにスキップ

はじめに

To be able to access certain components like the hard drive or motherboard of the Dell Studio 1555, the back panel will need to be removed. A Phillips 1 screwdriver is required for this guide.

パーツ

パーツは指定されていません。

  1. Turn off and unplug the laptop.
    • Turn off and unplug the laptop.

    • Failure to properly turn off device before handling the battery could result in electrical shock.

    • Flip the laptop so the underside is facing up with the battery closest to you.

  2. Slide the locking switch to the left to release the battery. Slide the locking switch to the left to release the battery. Slide the locking switch to the left to release the battery.
    • Slide the locking switch to the left to release the battery.

  3. iPhoneのバッテリーキット

    Only $29.99

    Buy Now

    iPhoneのバッテリーキット

    Only $29.99

    Buy Now
  4. Gently pull the battery away from the device.
    • Gently pull the battery away from the device.

  5. Loosen the three 5mm screws from the back panel using the # 1 Philips  screwdriver. The three 5mm screws will stay in place on the back panel. The three 5mm screws will stay in place on the back panel.
    • Loosen the three 5mm screws from the back panel using the # 1 Philips screwdriver.

    • The three 5mm screws will stay in place on the back panel.

  6. Carefully remove the separated back panel.
    • Carefully remove the separated back panel.

    • If the back panel is difficult to remove and feels like it is going to break, DO NOT force it. Check to confirm that all the screws are unscrewed all the way before attempting again.

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Josh Boone

メンバー登録日: 2016年10月10日

562 ポイント

4のガイドは作成済み

チーム

Sam Houston State, Team 12-3, Blackburne Fall 2016 Sam Houston State, Team 12-3, Blackburne Fall 2016人のメンバー

SHSU-BLACKBURNE-F16S12G3

3 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 4

今までの合計 264