Dell Streak 10 Pro Rear Camera Replacement

はじめに

If you need to reinstall a new rear camera, follow this guide to access the motherboard and the camera. For this guide you will be needing a plastic opening tool, a Phillips #0 screwdriver, and tweezers.

必要な工具と部品

手順1 Battery

Dell Streak 10 Pro Rear Camera Replacement, Battery: 手順 1、 3の画像 1

Dell Streak 10 Pro Rear Camera Replacement, Battery: 手順 1、 3の画像 2

Dell Streak 10 Pro Rear Camera Replacement, Battery: 手順 1、 3の画像 3

Place the device flat on its screen.
Using the plastic opening tools, pry open the top segment of the tablet where the camera is located.
Take the segment off and place it to the side.

編集

手順2

Remove four 4mm Phillips #0 screws.

編集

手順3

Using the plastic opening tool, lift off the entire back screen of the tablet.

編集

手順4

Dell Streak 10 Pro Rear Camera Replacement: 手順 4、 3の画像 3

この手順で使用する道具：

Tweezers

$4.99

購入する

Disconnect the no-fuss ribbon cable connector.
The best way is to safely pull the white connector straight out of the socket. Using the tweezers, pull out the white connector that contains the red, green, blue, and black cords connected to it.
Remove the battery by gently lifting it out of the device.

編集

手順5 Rear Camera

Dell Streak 10 Pro Rear Camera Replacement, Rear Camera: 手順 5、 2の画像 1

Dell Streak 10 Pro Rear Camera Replacement, Rear Camera: 手順 5、 2の画像 2

この手順で使用する道具：

Tweezers

$4.99

購入する

Disconnect the no-fuss ribbon cable connector. Using tweezers, carefully pull the connector straight out of the socket.
The white connector is attached to a black wire.

編集

手順6

Disconnect the delicate ribbon cable from the Zero Insertion Force (ZIF) Connector.
To disconnect the cable, use the tip of a spudger or your fingernail to flip up the small black locking flap. Then, you can safely pull the cable out.

編集