メインコンテンツにスキップ

Dell Inspiron 17R-N7010 Fan Replacement

必要な工具と部品

  1. Dell Inspiron 17R-N7010 Fan Replacement, Battery: 手順 1、 1の画像 1
    • Flip over the laptop so the back is facing upwards.

    • Locate the battery compartment.

    • Make sure your laptop is turned off before disassembly.

  2. Dell Inspiron 17R-N7010 Fan Replacement: 手順 2、 1の画像 1
    • Slide both locks away from the center of the battery.

    • After you hear a click, pull out the battery.

  3. Dell Inspiron 17R-N7010 Fan Replacement, Palm Rest: 手順 3、 3の画像 1 Dell Inspiron 17R-N7010 Fan Replacement, Palm Rest: 手順 3、 3の画像 2 Dell Inspiron 17R-N7010 Fan Replacement, Palm Rest: 手順 3、 3の画像 3
    • Remove the four screws from the back panel.

    • Flip the laptop over and open it to view the keyboard.

    • Disconnect the keyboard from the laptop by lifting up the latch holding the ribbon cable in place.

  4. Dell Inspiron 17R-N7010 Fan Replacement: 手順 4、 3の画像 1 Dell Inspiron 17R-N7010 Fan Replacement: 手順 4、 3の画像 2 Dell Inspiron 17R-N7010 Fan Replacement: 手順 4、 3の画像 3
    • Close the laptop and flip it over so the bottom is facing upwards.

    • Remove the two screws from the small panel.

    • Remove the small back panel.

    • Slide the CD drive out of the laptop.

    • Remove the three screws from the CD drive slot.

  5. Dell Inspiron 17R-N7010 Fan Replacement: 手順 5、 1の画像 1
    • This step is tricky and can feel like you are breaking the laptop. Follow the next steps with caution to avoid damaging the laptop.

    • Remove the top cover by inserting a spudger under the surface.

    • Working clockwise, pry upwards with the spudger to detach the clips.

  6. Dell Inspiron 17R-N7010 Fan Replacement: 手順 6、 2の画像 1 Dell Inspiron 17R-N7010 Fan Replacement: 手順 6、 2の画像 2
    • Disconnect the ribbon cables.

    • Remove the cover to access the inner hardware of the laptop.

  7. Dell Inspiron 17R-N7010 Fan Replacement, Fan: 手順 7、 3の画像 1 Dell Inspiron 17R-N7010 Fan Replacement, Fan: 手順 7、 3の画像 2 Dell Inspiron 17R-N7010 Fan Replacement, Fan: 手順 7、 3の画像 3
    • Locate the fan at the top left corner.

    • Remove the fan by disconnecting the coupled wires from the white port.

    • Disconnect the wire strip by lifting up the latch holding the wire in place.

    • Unscrew the remaining two screws.

    • Remove the fan.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

5人の作成者と共同で作成されました。

Brandon Lopez

メンバー登録日: 09/21/18

319 ポイント

3のガイドは作成済み

チーム

University of North Texas, Team S8-G5, Riccardelli Fall 2018 University of North Texas, Team S8-G5, Riccardelli Fall 2018人のメンバー

UNT-RICCARDELLI-F18S8G5

4 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 12

今までの合計 1,100