はじめに

Use this guide to replace the RAM if you would like to upgrade the RAM, or replace it if there is damage.

パーツ

パーツは必要ありません。

Make sure the display is closed. Then, flip the computer over so that you can see the bottom cover.
  • Make sure the display is closed. Then, flip the computer over so that you can see the bottom cover.

  • Loosen the two 5 mm Phillips #0 on the upper edge of the cover.

    • These screws will stay captive to the case.

コメントを追加する

Remove the two 5 mm interior screws that connect the cover to the assembly using the same Philips head screwdriver from the previous step.
  • Remove the two 5 mm interior screws that connect the cover to the assembly using the same Philips head screwdriver from the previous step.

コメントを追加する

  • Use a spudger to remove the base cover from the rest of bottom cover.

As it is not clearly visible in the picture: You should start to open the base cover at the screen side, to avoid breaking the plastic guides of the base cover. A flat dough scraper is a pretty good tool for that.

David Jatzke - 返信

  • Gently pull apart clips on the ends of the memory module until the memory module pops up.

コメントを追加する

  • Pull the RAM out at a 45 degree angle.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Jean Whitmore

メンバー登録日: 2015年01月22日

920 ポイント

7のガイドは作成済み

チーム

Cal Poly, Team 18-2, Maness Winter 2015 Cal Poly, Team 18-2, Maness Winter 2015人のメンバー

CPSU-MANESS-W15S18G2

4 メンバー

8のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 5

過去 30 日: 25

今までの合計 1,477