メインコンテンツにスキップ

はじめに

In this guide, we will show you how to remove and replace the Hard drive.

パーツ

パーツは指定されていません。

  1. WARNING:  Before working inside your computer, read the safety  information that shipped with your computer and follow the steps in Before You Begin.
    • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before You Begin.

    • WARNING: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.

    • Loosen the captive screws that secure the hard-drive assembly to the computer base.

  2. Using the pull-tab, lift the hard-drive assembly to disconnect it from the connector on the system board.
    • Using the pull-tab, lift the hard-drive assembly to disconnect it from the connector on the system board.

  3. Lift the hard-drive assembly out of the computer base.
    • Lift the hard-drive assembly out of the computer base.

  4. Remove the screws that secure the hard drive to the hard-drive bracket.
    • Remove the screws that secure the hard drive to the hard-drive bracket.

  5. MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now

    MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now
  6. Lift the hard-drive off the hard-drive bracket. Lift the hard-drive off the hard-drive bracket.
    • Lift the hard-drive off the hard-drive bracket.

  7. Remove the interposer from the hard drive.
    • Remove the interposer from the hard drive.

  8. Connect the interposer to the NEW hard drive. Connect the interposer to the NEW hard drive.
    • Connect the interposer to the NEW hard drive.

  9. Place the hard drive in the hard-drive bracket. Place the hard drive in the hard-drive bracket.
    • Place the hard drive in the hard-drive bracket.

  10. Replace the screws that secure the hard drive to the hard-drive bracket.
    • Replace the screws that secure the hard drive to the hard-drive bracket.

  11. Align the connector on the hard drive with the connector on the system board and press the hard drive until it is fully seated.
    • Align the connector on the hard drive with the connector on the system board and press the hard drive until it is fully seated.

  12. Tighten the captive screws that secure the hard-drive assembly to  the computer base.
    • Tighten the captive screws that secure the hard-drive assembly to the computer base.

まとめ

To reassemble your device, follow these instructions in reverse order.

Terrence15

メンバー登録日: 2017年12月18日

70,993 ポイント

442のガイドは作成済み

チーム

Informative Technologies Inc. Informative Technologies Inc.人のメンバー

Community

15 メンバー

930のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 6

過去 30 日: 22

今までの合計 350