DeWalt DWE4011 Carbon Brushes Replacement - iFixit 修理ガイド

はじめに

The carbon brushes are one part that both wears out quickly and can cause a wide variety of problems if faulty. Follow these simple steps to replace them.

必要な工具と部品

手順1 Carbon Brushes

DeWalt DWE4011 Carbon Brushes Replacement, Carbon Brushes: 手順 1、 1の画像 1

Turn to the bottom of the device and remove the 5/8" (17mm) T15 Torx screw shown using a T15 Torx Screwdriver.

手順2

DeWalt DWE4011 Carbon Brushes Replacement: 手順 2、 1の画像 1

Remove the outer casing to expose the brushes by pulling the end handle away from the field case.

手順3

DeWalt DWE4011 Carbon Brushes Replacement: 手順 3、 2の画像 1

DeWalt DWE4011 Carbon Brushes Replacement: 手順 3、 2の画像 2

Locate both carbon brushes on either side of the device.

手順4

DeWalt DWE4011 Carbon Brushes Replacement: 手順 4、 1の画像 1

Using the iFixit opening tool, remove the female terminal connecting the carbon brush wire to the male terminal.

手順5

DeWalt DWE4011 Carbon Brushes Replacement: 手順 5、 1の画像 1

Keeping a tight hold the entire time, move the spring covering the carbon brush so that it is behind the male terminal.
Be extremely careful, as the spring is tightly coiled and can easily get away from you.

手順6

DeWalt DWE4011 Carbon Brushes Replacement: 手順 6、 2の画像 1

DeWalt DWE4011 Carbon Brushes Replacement: 手順 6、 2の画像 2

Taking hold of the wire you removed in step 4, gently slide the carbon brush out of its casing and remove it from the device.
Flip over the device to reveal the second carbon brush, and repeat steps 4 through 6 on the other side.

終わりに

Congratulations! To put your device back together, simply reverse the above steps.

作成者

3人の作成者と共同で作成されました。

Kiera Sloan

メンバー登録日: 04/03/19

145 ポイント

1ガイドが承認済み

チーム

Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019 Oregon Institute of Technology, Team S2-G9, Lancaster Spring 2019人のメンバー

OIT-LANCASTER-S19S2G9

4 メンバー

5のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 1

過去 7 日: 6

過去 30 日: 27

今までの合計 1,282