メインコンテンツにスキップ

はじめに

The DeWalt DW660 has an amazing dynamic power switch that makes operating the device extremely easy. The bump off feature of the switch allows for an easy shut off with minimal effort.

パーツ

パーツは指定されていません。

  1. Remove the four 19mm T20 Torx screws at the rear of the device.
    • Remove the four 19mm T20 Torx screws at the rear of the device.

  2. Remove the cover to expose the inside of the tool.
    • Remove the cover to expose the inside of the tool.

  3. Pick up the switch from the device with the wires still attached. Remove the actuator from the switch. Pull the two wires from the switch.
    • Pick up the switch from the device with the wires still attached.

    • Remove the actuator from the switch.

    • Pull the two wires from the switch.

    • Make sure to remember where each pin went on the switch after replacement.

終わりに

To reassemble your device, follow these instructions in reverse order.

Joseph Pacitto

メンバー登録日: 2016年03月23日

239 ポイント

2のガイドは作成済み

チーム

UMass Dartmouth, Team 2-7, Isaacson Spring 2016 UMass Dartmouth, Team 2-7, Isaacson Spring 2016人のメンバー

UMASSD-ISAACSON-S16S2G7

3 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 1

過去 7 日: 1

過去 30 日: 4

今までの合計 210