Daisy Model 10 Carbine Cocking Lever Replacement

はじめに

To repair your cocking lever you will need a Phillips 2 screwdriver. In addition to this, this manual requires you to remove a small screw and washer from the carbine. To avoid losing these, replace your cocking lever on a table or similar workspace.

必要な工具と部品

手順1 Removing Screws

Daisy Model 10 Carbine Cocking Lever Replacement, Removing Screws: 手順 1、 3の画像 1

Daisy Model 10 Carbine Cocking Lever Replacement, Removing Screws: 手順 1、 3の画像 2

Daisy Model 10 Carbine Cocking Lever Replacement, Removing Screws: 手順 1、 3の画像 3

Make sure the safety is on!
Place the carbine with the saddle ring and leather thong facing upwards.
Locate the screw head on the cocking lever.
There should be one on either side of the saddle ring and one on the cocking lever assembly.
Place a #2 Phillips Screwdriver in the 11/16ths of an inch, matte black screw on the cocking lever assembly. Twist with a counter-clockwise motion.
Completely remove the screws.
Be wary of the black washers on the other side of the Carbine. Be sure to keep track of them once they fall out after the screws are removed

編集

手順2 Removing the Lever

Daisy Model 10 Carbine Cocking Lever Replacement, Removing the Lever: 手順 2、 2の画像 1

Daisy Model 10 Carbine Cocking Lever Replacement, Removing the Lever: 手順 2、 2の画像 2

Remove the cocking lever by placing your dominant hand’s fingers through the cocking lever handle.
With your fingers in the handle, slide the lever towards the butt of the carbine.
Finally, pull the cocking lever and carbine in opposite directions to replace the cocking lever.