修理を始めるには コミュニティ ストア

Craig Electronics CMP773 Front and Rear Camera Replacement

はじめに

If the camera on your Craig Electronics CMP773 Tablet is scratched, damaged, or malfunctioning for any reason, you may find yourself needing to replace it. This guide will lead you through replacing the camera unit on your tablet. Note that the front and rear cameras are attached to the same electronic circuit, so the replacement part is just one unit for both cameras.

必要な工具と部品

  1. Craig Electronics CMP773 Front and Rear Camera Replacement, Front and Rear Camera: 手順 1、 2の画像 1 Craig Electronics CMP773 Front and Rear Camera Replacement, Front and Rear Camera: 手順 1、 2の画像 2

    • Remove the two Phillips #00 screws from the bottom of the screen.

    編集

  2. Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 2、 2の画像 1 Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 2、 2の画像 2

    • Insert a plastic opening tool underneath the screen.

    • Once the first tool is inserted, insert another opening tool along the same side of the tablet.

    • Pry them in opposite directions until the casing pops.

    編集

  4. Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 3、 2の画像 1 Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 3、 2の画像 2

    • Move the opening tool along the edge of the tablet to continue popping the casing loose.

    • Once the casing is about half loose, remove it by hand.

    編集

  5. Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 4、 2の画像 1 Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 4、 2の画像 2

    • Remove the tape from the power connection for the camera unit.

    • Unhinge the clamp on the camera power connection to expose the removable plug.

    編集

  6. Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 5、 1の画像 1

    • Gently remove the power ribbon from the connector.

    編集

  7. Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 6、 2の画像 1 Craig Electronics CMP773 Front and Rear Camera Replacement: 手順 6、 2の画像 2

    • Use the spudger to dislodge camera unit from the casing and remove it from the device.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

Luke VanLangevelde

メンバー登録日: 11/07/19

133 ポイント

1ガイドが承認済み

バッジ: 2

チーム

IUPUI, Team S3-G4, Harley Fall 2019 IUPUI, Team S3-G4, Harley Fall 2019人のメンバー

IUPUI-HARLEY-F19S3G4

4 メンバー

3のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 3

今までの合計 83