Cobra 29 LTD Classic Outer Cover Replacement

はじめに

This outer cover is the main cover that protects the inner electrical components. Perform the guide on a flat non-conductive surface to avoid electrical shock and damage to your device.

必要な工具と部品

手順1 Power Cable

Cobra 29 LTD Classic Outer Cover Replacement, Power Cable: 手順 1、 2の画像 1

Cobra 29 LTD Classic Outer Cover Replacement, Power Cable: 手順 1、 2の画像 2

Turn the power switch, the leftmost knob, counterclockwise to off.

編集

手順2

Turn the device around and firmly pull the power cable plug to remove it from the radio.

編集

手順3 Antenna Cable

Cobra 29 LTD Classic Outer Cover Replacement, Antenna Cable: 手順 3、 2の画像 1

Cobra 29 LTD Classic Outer Cover Replacement, Antenna Cable: 手順 3、 2の画像 2

Unscrew the securing cap counterclockwise from the antenna connector.

編集

手順4

Gently pull the antenna cable to remove it from the back of the radio.

編集

手順5 Microphone

Cobra 29 LTD Classic Outer Cover Replacement, Microphone: 手順 5、 2の画像 1

Cobra 29 LTD Classic Outer Cover Replacement, Microphone: 手順 5、 2の画像 2

Unscrew the cap counterclockwise on the microphone plug to disconnect the cable.

編集

手順6

Gently unplug the microphone plug.

編集

手順7 Outer Cover

Cobra 29 LTD Classic Outer Cover Replacement, Outer Cover: 手順 7、 2の画像 1

Cobra 29 LTD Classic Outer Cover Replacement, Outer Cover: 手順 7、 2の画像 2

Unscrew the top four 6.0mm Phillips head screws counterclockwise on the left and right side of the device using a #1 Phillips head screwdriver.

編集

手順8

Cobra 29 LTD Classic Outer Cover Replacement: 手順 8、 3の画像 3

Gently life and remove the top cover.

編集

手順9

Cobra 29 LTD Classic Outer Cover Replacement: 手順 9、 3の画像 3

Gently set down on a hard, flat, non-conductive surface to minimize risk of shock or breaking your radio.
Carefully flip the radio over.

編集

手順10

Unscrew the four 6.0mm Phillips head screws counterclockwise on the left and right side of the device that connect the remaining cover, using a #1 Phillips head screwdriver.

編集

手順11

Cobra 29 LTD Classic Outer Cover Replacement: 手順 11、 3の画像 3

Watch out for the wires connected to the speaker. These short wires will not allow you to move the cover very far.
Gently lift and remove the case cover.

編集