Chamberlain Garage Door Sensor Replacement

はじめに

The garage door sensors prevent the garage door from closing on an object or a person in the garage doorway when it is attempting to close. When the sensors are faulty, the garage door remote may not work when pressed, causing the lights on the unit to blink.

This guide shows how to replace a Chamberlain garage door sensor. It is an easy procedure to perform and should take about thirty to forty-five minutes to complete. Minimal tools are required for this Fast Fix: a pair of wire strippers, a pair of pliers, and a step ladder.

The purchase of the replacement sensor based on the brand of garage door system is the part that is required to complete this project.

必要な工具と部品

手順1 Sensor

Chamberlain Garage Door Sensor Replacement, Sensor: 手順 1、 1の画像 1

Use a step ladder to reach and unplug the garage door opener power cord.

編集

手順2

Remove the wingnut from the safety sensor bracket.
Turn counter-clockwise until the wingnut is completely removed.

編集

手順3

Pull the sensor from the bracket.
Be careful not to lose the screw that attaches the sensor to the bracket.

編集

手順4

Use the wire stripper or pliers to cut the wires for the sensor about an inch from the safety sensor.
This step removes the old sensor.

編集

手順5

Chamberlain Garage Door Sensor Replacement: 手順 5、 3の画像 3

Separate the ends of the wires
Use the wire stripper to strip the ends of the wires for the new sensor.
This step prepares the new sensor to be connected to the wiring for the garage door opener.

編集

手順6

Chamberlain Garage Door Sensor Replacement: 手順 6、 3の画像 3

Separate the ends of the wires and use the wire stripper to strip the ends of the wires going into the wall.
This step prepares the garage door opener wiring to be connected to the new sensor.

編集

手順7

Chamberlain Garage Door Sensor Replacement: 手順 7、 3の画像 3

Match the wires from the wall and from the new sensor and connect them with the crimp by inserting two like-kind wires in one crimp with one wire going into each side.
The black striped goes with the black striped wire.

編集

手順8

Chamberlain Garage Door Sensor Replacement: 手順 8、 3の画像 3

Use the pair of pliers to press down on the round section of the crimp to seal the connection.
Repeat for the other wire.

編集

手順9

With the wiring connected, slide the new sensor into the bracket.

編集

手順10

Attach the wingnut and tighten the new sensor to the bracket.

編集

手順11

Repeat the process for the other sensor on the other side of the garage door.

編集

手順12

Use a step ladder to reach and plug in the power cord for the garage door sensor.

編集

手順13

Gently wiggle the sensors to align them.
When the sensors are aligned, the sensor with the green safety light glows steadily.

編集

手順14

Chamberlain Garage Door Sensor Replacement: 手順 14、 3の画像 3

Place a box between the sensors and press the garage door button to close the garage door. The garage door should return to its starting point and the garage door light flash. This result means that the new sensors are working properly.

編集