はじめに

This guide will walk you through removing a faulty or damaged viewfinder.

  1. Open the battery compartment and remove the batteries.
    • Open the battery compartment and remove the batteries.

    • Remove the two screws that are deep in the battery compartment.

    コメントを追加する

  2. Open the CF compartment and remove the top screw
    • Open the CF compartment and remove the top screw

    • The panel, that holds the shutter button and zoom, will come off.

      • Be careful! There are two small wires connecting the speaker to the body of the camera. These are very delicate so proceed with caution. Do not remove.

    コメントを追加する

    • Unscrew the three small screws on the bottom.

    • remove the wrist strap

    コメントを追加する

    • Remove the screw in the CF compartment.

    コメントを追加する

    • Open the rubber Digital AV Out compartment flap.

      • Pry the battery with the IFIXIT opening tool.

      • Carefully pull out the battery with two fingers.

        • Unscrew the two screws that are now visible.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • Starting from the bottom, carefully pull the casing off.

    • The casing will now pivot at the top.

      • There are three catches that hold the back casing to the body.

      • You may have to pull with some force. The rear panel will make a snapping noise when it separates from the body.

    コメントを追加する

    • The interior of the camera should look like this.

    コメントを追加する

    • Remove the two screws at the top of the battery compartment.

    コメントを追加する

    • With your right thumb, pull back on the tab while using your left hand to pull the face of the camera away from the body.

    コメントを追加する

    • After removing the front and rear panels, locate the viewfinder directly above the lens on top of the camera.

    • Three screws hold the viewfinder in place. Two on the top and one on the lens side of the camera.

    • First, remove the screw in the bent corner of the viewfinder.

    コメントを追加する

    • Next, remove the 2nd screw directly across from the bent corner. It may be hidden in the space under the orange circuitry.

    コメントを追加する

    • Lastly, remove the final screw directly under the left side of the viewfinder (on the lens side).

    コメントを追加する

    • After removing the three screws, the only thing still holding the viewfinder in place is a small plastic peg.

    • Remove the viewfinder with a firm pull directly upwards.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Logan

メンバー登録日: 2010年01月26日

6 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 14-40, Regan Winter 2010 Cal Poly, Team 14-40, Regan Winter 2010人のメンバー

CPSU-REGAN-W10S14G40

5 メンバー

8のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 5

今までの合計 6,631