はじめに

Follow these instructions to remove and install a new backlight.

Turn off camera by pressing power button above the LCD screen.
  • Turn off camera by pressing power button above the LCD screen.

  • Remove the battery and memory card.

コメントを追加する

Remove the screws on the bottom of the camera using a 00 Philip's head screw driver
  • Remove the screws on the bottom of the camera using a 00 Philip's head screw driver

コメントを追加する

Remove the screws on the right side of the camera.
  • Remove the screws on the right side of the camera.

コメントを追加する

Remove the screws on the left of the camera underneath the "A/V out Digital" cover flap.
  • Remove the screws on the left of the camera underneath the "A/V out Digital" cover flap.

コメントを追加する

Remove the screws on the bottom of the camera near the battery and the memory card slots.
  • Remove the screws on the bottom of the camera near the battery and the memory card slots.

  • This screw is longer than the rest of the screws.

コメントを追加する

Remove the front back and side casings from the camera.
  • Remove the front back and side casings from the camera.

コメントを追加する

Remove the two screws that connect the LCD and backlight to the main body of the camera.
  • Remove the two screws that connect the LCD and backlight to the main body of the camera.

コメントを追加する

Gently pry the LCD and the backlight from the main body of the camera. Gently pry the LCD from the backlight. The thin ribbon cable is for the backlight.
  • Gently pry the LCD and the backlight from the main body of the camera.

  • Gently pry the LCD from the backlight.

    • The thin ribbon cable is for the backlight.

    • The thick ribbon cable is for the LCD screen.

コメントを追加する

Carefully lift the ZIF connector that covers the thick ribbon cable.
  • Carefully lift the ZIF connector that covers the thick ribbon cable.

  • This ZIF connector is fragile. Use caution when lifting it from its down position.

  • Insert the new LCD and reassemble the camera.

コメントを追加する

Unplug the ribbon from the housing on the circuitry.
  • Unplug the ribbon from the housing on the circuitry.

  • Take the new ribbon and insert it into the housing.

    • Tweezers or a tool with a sharp point can be used.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Emilio Rossi

メンバー登録日: 2011年04月07日

113 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 9-71, Walters Spring 2011 Cal Poly, Team 9-71, Walters Spring 2011人のメンバー

CPSU-WALTERS-S11S9G71

4 メンバー

8のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 1,482