はじめに

This guide offers detailed, step-by-step instructions for replacing a faulty LCD screen on your Canon PowerShot SD400. The LCD, or liquid crystal display, serves as the camera's monitor for images, and it may require replacement if you notice cracks, discolored pixels, spots, blobs, flickering, or a complete loss of image signal. Before you get started, make sure to power off the camera and remove the battery.

必要な工具と部品

手順1 Battery

Canon PowerShot SD400 LCD Replacement, Battery: 手順 1、 2の画像 1

Canon PowerShot SD400 LCD Replacement, Battery: 手順 1、 2の画像 2

Slide the battery cover open (indicated by the red box).

編集

手順2

Push in the orange clip (indicated by the red box) to eject the battery.

編集

手順3

Insert the charged battery back into the slot (indicated by the red box).
Close the cover.

編集

手順4 LCD

Canon PowerShot SD400 LCD Replacement, LCD: 手順 4、 3の画像 1

Canon PowerShot SD400 LCD Replacement, LCD: 手順 4、 3の画像 2

Canon PowerShot SD400 LCD Replacement, LCD: 手順 4、 3の画像 3

Locate these six screws that need to be removed to open the camera’s housing. These screws can be found on the bottom and both sides of the camera.

編集

手順5

Canon PowerShot SD400 LCD Replacement: 手順 5、 3の画像 3

Using the screwdriver, carefully remove the exterior screws and place them in a safe location to avoid misplacing them.

編集

手順6

Locate the interior screw that is above the top right of the LCD screen.
Remove the screw using the screwdriver.

編集

手順7

Canon PowerShot SD400 LCD Replacement: 手順 7、 3の画像 3

Locate the two clips on the left side of the LCD screen.
Carefully insert the tip of a flat-head screwdriver under the two clips of the LCD screen.
Slowly lift the screen using the flat-head screwdriver.
Potential for device damage Lift the screen gently to avoid any damage.