はじめに

This guide is a walk-through of the process to replace a dead, dying, or incorrectly placed battery and an SD card in a Canon PowerShot SD 600.

Turn the camera over so that the battery compartment is visible. The compartment should read "Card/Batt. Open".
  • Turn the camera over so that the battery compartment is visible. The compartment should read "Card/Batt. Open".

  • Open the compartment.

    • Lightly push the compartment lid down and outward. The arrow next to "Card/Batt. Open" indicates the direction you should be pushing.

コメントを追加する

Once the lid is open, the battery and SD card compartments become visible.
  • Once the lid is open, the battery and SD card compartments become visible.

  • Notice the red tab on the right side of the battery.

    • Slide this tab off the battery.

    • The battery is now free to slide out of the compartment.

    • The battery will not pop out of the compartment. The camera needs to be tilted in order to slide the battery out.

コメントを追加する

  • To remove the SD card push it down and it will eject out. (SD card not shown)

  • Be sure the new or recharged battery is facing the correct direction. An arrow on the battery indicates which end should be inserted into the compartment first.

  • If you plan on dissembling the camera further, you should leave the battery and SD card removed. Make sure to close the battery compartment once the battery and the SD card are removed.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Krystal Eades

メンバー登録日: 2013年03月11日

1 ポイント

4のガイドは作成済み

チーム

Clemson, Team 13-5, Benson Spring 2013 Clemson, Team 13-5, Benson Spring 2013人のメンバー

CLEM-BENSON-S13S13G5

3 メンバー

11のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 221