はじめに

This guide demonstrates how to remove the cameras back panel for cleaning or replacement.

パーツ

パーツは必要ありません。

  1. Turn the camera with the bottom side facing up.
    • Turn the camera with the bottom side facing up.

    • Locate the panel labeled "Batt. Open"

    • Place your finger on the panel and slide it in the direction of the arrow.

    • The slot will swing open revealing the battery pack.

    コメントを追加する

  2. Rotate the camera so that the slot is horizontal.
    • Rotate the camera so that the slot is horizontal.

    • Pull the orange lever and the battery will spring out slightly.

    コメントを追加する

    • Grasp battery and fully pull out of slot

    • When placing the new battery back in the slot, the arrow on the battery must align with the arrow on the camera.

    コメントを追加する

    • Start by laying the camera flat with the LCD screen facing up.

    • Remove the 3.8mm screw in the upper right corner.

    コメントを追加する

    • Position the camera with the bottom facing up.

    • Remove the 4.8mm screw.

    • Remove the two 2.3mm screws.

    コメントを追加する

    • Position the camera so that the rubber "AV Out Digital" tab is facing upward.

    • Slide this rubber tab out of the way to reveal the bottom screw.

    • Remove the two 3.7mm screws.

    コメントを追加する

    • Turn the camera with the back side facing you.

    • Grip the edges of the back plate, and carefully slide it off.

    • If there is any resistance in movement, double check there are no screws left in the chassis.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Randy Lormand

メンバー登録日: 2011年01月23日

331 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 11-27, Maness Winter 2011 Cal Poly, Team 11-27, Maness Winter 2011人のメンバー

CPSU-MANESS-W11S11G27

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 943