はじめに

Use this guide to replace the Canon Powershot A75's speaker unit.

パーツ

パーツは必要ありません。

Turn the camera over and locate the "BATT OPEN" sliding switch.
  • Turn the camera over and locate the "BATT OPEN" sliding switch.

コメントを追加する

Slide the switch to the right. The battery cover should slide down and spring open. The battery cover should slide down and spring open.
  • Slide the switch to the right.

    • The battery cover should slide down and spring open.

コメントを追加する

Remove the 4 AA batteries. Watch for the orientation of the batteries as they slide out. The battery orientation is shown under the battery flap itself and on a sticker next to the battery flap.
  • Remove the 4 AA batteries.

    • Watch for the orientation of the batteries as they slide out.

    • The battery orientation is shown under the battery flap itself and on a sticker next to the battery flap.

コメントを追加する

Open the memory card slot by sliding it laterally until you hear a click Remove the 5.9mm screw in the upper corner of the memory card slot
  • Open the memory card slot by sliding it laterally until you hear a click

  • Remove the 5.9mm screw in the upper corner of the memory card slot

コメントを追加する

Remove the two 4.1mm screws at the bottom of the battery flap.
  • Remove the two 4.1mm screws at the bottom of the battery flap.

コメントを追加する

Lift the shutter button and speaker part from the top of the camera. Do not pull the part too hard because there is a plug connecting the speaker to the camera.
  • Lift the shutter button and speaker part from the top of the camera.

    • Do not pull the part too hard because there is a plug connecting the speaker to the camera.

コメントを追加する

Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out. Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out. Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out.
  • Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out.

コメントを追加する

Do not proceed to the next step unless you have previous soldering experience because you can damage the flash unit if you are not careful.
  • Do not proceed to the next step unless you have previous soldering experience because you can damage the flash unit if you are not careful.

  • Remove the glue and unsolder the speaker from the outer casing. Replace or repair the speaker as necessary.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Austin Fox

メンバー登録日: 2012年04月11日

1 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 17-30, Amido Spring 2012 Cal Poly, Team 17-30, Amido Spring 2012人のメンバー

CPSU-AMIDO-S12S17G30

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 268