Canon EOS Rebel XTi Front Casing Replacement

はじめに

Prerequisite Only

Removing the front portion of the casing is necessary to perform maintenance or replace parts on specific components on the front of the camera. In order to remove the front casing, the back will have to be removed first.

必要な工具と部品

手順1 Battery

Canon EOS Rebel XTi Front Casing Replacement, Battery: 手順 1、 1の画像 1

Place the camera upside down, and position it to where the back of the camera is visible.

編集

手順2

Pull the orange tab to the right to release the primary battery.

編集

手順3

To remove the secondary battery, reposition the camera to where the display screen is facing upwards.
Place your finger inside the empty battery compartment and pull away from the camera on the ridged battery tab.

編集

手順4 Memory Card

Canon EOS Rebel XTi Front Casing Replacement, Memory Card: 手順 4、 1の画像 1

Place the camera on its side with the soft touch grip facing up and the top of the camera facing right.

編集

手順5

Slide the memory card door in the direction of the arrow engraved on the camera.
Once the door has slid open to its full position, lift up on the door.

編集

手順6

With the door open, push down the small black plunger next to the CF slot. The CF card will disengage from the slot and be ejected far enough that you can grasp it between thumb and forefinger and remove it from the slot.
The plunger will stay in its depressed position until a CF card is again inserted in the slot.

編集

手順7 Back Casing

Canon EOS Rebel XTi Front Casing Replacement, Back Casing: 手順 7、 1の画像 1

Remove the three black 4 mm JIS #0 screws on the bottom of the camera.

編集

手順8

Remove the two black 6 mm Phillips screws from the right side of the camera.

編集

手順9

Canon EOS Rebel XTi Front Casing Replacement: 手順 9、 3の画像 3

Remove the two black 4 mm Phillips screws on each side of the camera under the strap hooks.

編集

手順10

Remove the two black 4 mm Phillips head screws on the side of the camera opposite to the hand grip.

編集

手順11

Remove the three 1 mm Phillips #0 screws located in the memory card slot.
Two of these screws are black, and the third is silver.

編集

手順12

Gently pry off the back casing.
Before completely removing the back casing, be sure to disconnect the single ribbon cable running from the motherboard to the LCD display.
Use a spudger to lift the tab on the ribbon cable's ZIF connector.
Gently pull the ribbon cable out of the connector.