はじめに

Use this guide to replace the LCD. The LCD tends to fade after about five years.

パーツ

パーツは必要ありません。

  1. Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.
    • Remove the two 3mm (1/8") black screws from the side cover using a #00 Phillips screwdriver.

  2. On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.
    • On the bottom, remove the 6mm (13/64") screw with the #00 Phillips Screwdriver.

    • Pry up the panel; starting from the front/bottom corner, as indicated.

    • There's a concealed lip, under the opposite edge.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  4. Remove the three long black screws from the bottom using a #00 Phillips screwdriver.
    • Remove the three long black screws from the bottom using a #00 Phillips screwdriver.

    • Use tweezers to lift the panel.

  5. Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.
    • Once you have detached the back cover, use a pair of tweezers to lightly pull on strap found connecting the back cover to the camera.

  6. Use the tweezers to gently remove the straps (in the teal box).
    • Use the tweezers to gently remove the straps (in the teal box).

    • Use the Phillips Screwdriver to remove the four screws (in the red dots).

    • Use your fingers to remove the silver plate.

  7. Use the Spudger on the edges of the screen.
    • Use the Spudger on the edges of the screen.

    • Once one end is lose, use the tweezers to lift the screen.

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Daniel Bussone

メンバー登録日: 2011年01月28日

1,239 ポイント

11のガイドは作成済み

チーム

Cal Poly, Team 3-41, Regan Winter 2011 Cal Poly, Team 3-41, Regan Winter 2011人のメンバー

CPSU-REGAN-W11S3G41

2 メンバー

11のガイドは作成済み

統計データを表示:

過去 24時間: 1

過去 7 日: 4

過去 30 日: 10

今までの合計 6,809