はじめに

This guide shows you how to install a new lens connector.

パーツ

パーツは必要ありません。

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

コメントを追加する

Using your finger, peel back the textured grip so the components are separated. Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

コメントを追加する

Using the flat end of a spudger, loosen the connection between the front panel and the device. Remove the front panel using your hands. Remove the front panel using your hands.
  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

コメントを追加する

Using a Phillips #00 screwdriver, remove the 5 indicated screws
  • Using a Phillips #00 screwdriver, remove the 5 indicated screws

    • Five 6.2 mm Phillips screws

コメントを追加する

Using your hands, remove the top black ring.
  • Using your hands, remove the top black ring.

  • WARNING! The indicated piece is spring loaded. Prepare for it to eject when taking off top ring.

    • Spring located here.

コメントを追加する

There are two silver metal rings. Remove the top silver metal ring.
  • There are two silver metal rings.

  • Remove the top silver metal ring.

コメントを追加する

Remove the bottom silver ring.
  • Remove the bottom silver ring.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Zach

メンバー登録日: 2012年04月04日

40 ポイント

8のガイドは作成済み

チーム

Cal Poly, Team 14-9, Forte Spring 2012 Cal Poly, Team 14-9, Forte Spring 2012人のメンバー

CPSU-FORTE-S12S14G9

5 メンバー

12のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 5

今までの合計 1,381