はじめに

This guide shows you how to install the grip on your camera.

パーツ

パーツは必要ありません。

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

コメントを追加する

Using your finger, peel back the textured grip so the components are separated. Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

コメントを追加する

Using the flat end of a spudger, loosen the connection between the front panel and the device. Remove the front panel using your hands. Remove the front panel using your hands.
  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

コメントを追加する

Using a 00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws. on the inside of the camera.
  • Using a 00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws. on the inside of the camera.

コメントを追加する

Using a 00 Phillips screw driver, unscrew the two 4.3 mm Phillips screws on the side of the camera.
  • Using a 00 Phillips screw driver, unscrew the two 4.3 mm Phillips screws on the side of the camera.

  • Use your fingers to pull out the plug that is located between the screw holes.

コメントを追加する

Use the flat end of a spudger to pop the grip off and remove grip. Use the flat end of a spudger to pop the grip off and remove grip.
  • Use the flat end of a spudger to pop the grip off and remove grip.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Kyle Reis

メンバー登録日: 2012年04月02日

49 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 14-9, Forte Spring 2012 Cal Poly, Team 14-9, Forte Spring 2012人のメンバー

CPSU-FORTE-S12S14G9

5 メンバー

12のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 1,205