はじめに

This guide describes the steps necessary to replace the motherboard of the system. This board contains the circuitry for the amplification, power, and output.

Remove 2 screws from each side of the amplifier.
  • Remove 2 screws from each side of the amplifier.

コメントを追加する

Remove 2 screws on rear of device. Slide top cover up and back from main case.
  • Remove 2 screws on rear of device. Slide top cover up and back from main case.

コメントを追加する

  • Remove 3 screws on bottom of case.

  • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

コメントを追加する

  • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

  • It may require some wiggling, but it should slip out of the hole and then off of the cord.

コメントを追加する

  • Remove 2 screws from each side of the heatsink. These must be accessed from directly above the device.

  • Remove the green grounding wire from the mounting screw.

コメントを追加する

  • With the amplifier on it's side, remove the 4 screws that hold the motherboard frame to the main case.

  • Be sure to hold the motherboard with one hand while removing the mount screws.

コメントを追加する

  • Unscrew ground wire from main case.

  • De solder 4 wires coming from transformer.

  • The motherboard can now be lifted from the case. Any part that needs to be removed from it can be de-soldered.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Colby

メンバー登録日: 2010年04月15日

284 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 28-36, Regan Spring 2010 Cal Poly, Team 28-36, Regan Spring 2010人のメンバー

CPSU-REGAN-S10S28G36

4 メンバー

3のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 16

今までの合計 5,332