Cabinet Magnetic Catch Replacement

はじめに

Has your cabinet stopped closing after a long period of use? Your cabinets may be able to close but not completely. The cause might be your magnet catch.

The cabinet magnet catch is an important component to ensure cabinets stay closed. Learn how to replace it using a screwdriver, a few screws, and a new magnetic catch that comes with new parts.

必要な工具と部品

手順1 Cabinet Magnet Catch

Cabinet Magnetic Catch Replacement, Cabinet Magnet Catch: 手順 1、 2の画像 1

Cabinet Magnetic Catch Replacement, Cabinet Magnet Catch: 手順 1、 2の画像 2

Remove two screws from the the old magnetic catch using a Phillips #0 screwdriver.
Remove the magnetic catch from the shelf.
It is recommended you use a stubby screwdriver since you will be dealing with tight spaces of the cabinet shelf.

編集

手順2

Remove the screws securing the plates to the cabinet doors using a Phillips #0 screwdriver. Remove the plates.
Do this on the both sides.

編集

手順3

Cabinet Magnetic Catch Replacement: 手順 3、 3の画像 3

Place the new magnetic catch on the center of the shelf cabinet.
Ensure it is adjusted carefully by moving its width halfway out of the cabinet and aligned on each side.

編集

手順4

With your graphite pencil, mark the location of the screw holes so you know exactly where you placed it in case you get lost.

編集

手順5

Screw in two 10 mm screws on the new magnetic catch using a Phillips #0 screwdriver to secure it in place.
Ensure that you are maintaining alignment of the magnetic catch with the help of Step 4. Otherwise, you will repeat Step 3.
You may reuse the old screws from the removal in Step 1 to install the new magnetic catch.

編集

手順6

Close the cabinet and mark down the side of the cabinet door using a graphite pencil.
Do this on the other side.

編集

手順7

Screw in one 5mm screw on the new magnetic plate using a Phillips #0 screwdriver to secure it in place on one side of the cabinet door.
Ensure that you are maintaining alignment of the magnetic plates with the help of Step 6 and old screw holes.
Do this step on the other side with the second 5mm screw.
You may reuse the old screws from the removal in Step 2 to install the new magnetic plates.