Braven BRV-HD Charging Port Replacement

はじめに

Following this guide will show you how to access and replace the charging port. The Braven BRV-HD Battery Replacement is a prerequisite for this guide.

必要な工具と部品

手順1 Battery

Braven BRV-HD Charging Port Replacement, Battery: 手順 1、 2の画像 1

Braven BRV-HD Charging Port Replacement, Battery: 手順 1、 2の画像 2

Placing the device on its back with the BRV-HD logo facing up, remove the eight 5mm hexagon 2.0 screws on the front panel.
Make sure the device is turned off before starting.

編集

手順2

Lift the front panel off of the speaker using a plastic opening tool.

編集

手順3

Placing the device with the back panel facing up, remove the eight 5mm hexagon 2.0 screws from the back panel.

編集

手順4

Lift the back panel off of the device with a plastic opening tool.

編集

手順5

Turning the device on its side, unscrew the four 15mm hexagon 2.0 screws on the charging port panel.

編集

手順6

Remove the outer rubber flap and the plastic side port panel.

編集

手順7

Place the device on its front.
Loosen the four 12mm Phillips screws in the four corners with a J1 screwdriver.
Loosen the two 8mm Phillips screws in the center with a J1 screwdriver.
These screws are difficult to reach and will require a screwdriver extension piece.

編集

手順8

Pull off the rubber sleeve surrounding the speaker using your hands.
There is adhesive binding the sleeve to the speaker and force will be required to remove the sleeve.

編集

手順9

Lift the black covering off of the speaker using both hands.
Loose screws that you were unable to remove with the screwdriver will be removed when you lift off the black covering.

編集

手順10

Remove the four 12mm Phillips screws securing the two battery brackets with a J1 screwdriver.
Move any wires aside to have better access to the screws securing the battery.

編集

手順11

Remove the two brackets that hold down the battery using your hands.

編集

手順12

Use the plastic opening tool to lift up the battery.
Remove the battery using your hands.
The wires connecting the battery to the motherboard are still plugged in. Avoid pulling on the battery or these wires may break.

編集

手順13

この手順で使用する道具：

Tweezers

$4.99

購入する

Disconnect the wire attaching the battery to the motherboard.
There is green glue on the wire ports preventing the wires from falling out. Peel and remove this glue as necessary.
Be careful when pulling out the wires from their ports. The metal stems attached to the ports can break. A spudger or tweezers may help.

編集

手順14 Charging Port

Braven BRV-HD Charging Port Replacement, Charging Port: 手順 14、 3の画像 1

Braven BRV-HD Charging Port Replacement, Charging Port: 手順 14、 3の画像 2

Braven BRV-HD Charging Port Replacement, Charging Port: 手順 14、 3の画像 3

Disconnect the three plugs attached to the plastic charging port panel.
Remove and replace the plastic panel with a new one.
Be careful in removing the 3 plugs as they can break when being pulled out of their white sockets.