リペアコミュニティに参加 - アカウントの作成

はじめに

If you are experiencing any audio issues with the lower frequency sounds (the bass) such as distortion, muffling, quietness, or total absence of sound, you may need to replace your bass speaker.

必要な工具と部品

手順1 Battery

Bose SoundLink III Bass Speaker Replacement, Battery: 手順 1、 1の画像 1

Use a spudger to pry the rubber pads off of the bottom panel of the SoundLink.
The rubber pads should have enough adhesive to stick when you reassemble them at the end. If not, however, you may need your own adhesive.

翻訳

手順2

Remove the two 12.5 mm screws using a Phillips #2 screwdriver.
These screws may be difficult to remove. If necessary, use a lever for extra torque.
Remove the bottom panel.

翻訳

手順3

Flip the rear panel back to allow access to the SoundLink's battery.

翻訳

手順4

Remove the two 12.5 mm Phillips #2 screws from the sides of the battery.

翻訳

手順5 Motherboard

Bose SoundLink III Bass Speaker Replacement, Motherboard: 手順 5、 1の画像 1

Gently peel back the adhesive padding on either side of the inner back panel.
The adhesive for these pads is powerful, but you may require new adhesive if the original begins to fail.

翻訳

手順6

Remove the four 12.5 mm Phillips #2 screws mounting the outer case.
Slide off the outer case.

翻訳

手順7

Remove four screws from each of the four speakers (16 screws total) using a Torx #10 screwdriver.
All screws (excluding the two middle screws on the right side) are 12.5 mm in length. The aforementioned middle screws are 21 mm.

翻訳

手順8

Remove the two 12.5 mm screws which mount the top panel using a Phillips #2 screwdriver.
Now you should be able to lift the top panel off.

翻訳

手順9

Use a metal spudger to pry the device apart. You must use a metal spudger because of the great force necessary to pry it apart.
The circuitry for the buttons on the top panel may be found underneath, so use caution not to damage it.

翻訳