Skip to main content

ガイド紹介

Good bearings are essential for smooth ride. This guide will help you take out and replace the pulley bearings on the rear wheels of your Boosted Board. You can choose to replace the bearings with new ones, or just clean the existing bearings.

パーツ

パーツは指定されていません。

  1. Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench. Do Not Remove the Screws.
    • Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench.

    • Do Not Remove the Screws.

  2. Compress the motor mount back towards the wheel.
    • Compress the motor mount back towards the wheel.

    • While keeping the motor mount compressed, tighten one of the hex nuts that you loosened in the previous step.

    • The motor mounts are spring tensioned so it is necessary compress them to loosen the belts.

  3. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  4. Remove the axel nut with a 1/2" socket wrench Remove the axel nut with a 1/2" socket wrench
    • Remove the axel nut with a 1/2" socket wrench

  5. Rotate and pull counterclockwise until the wheel comes off the axle completely. The front washer will come off with the wheel. Remove the back washer from the axle.
    • Rotate and pull counterclockwise until the wheel comes off the axle completely.

    • The front washer will come off with the wheel.

    • Remove the back washer from the axle.

    • Replacing the wheel requires the bearings to be switched into the new wheel.

  6. Use one finger to pull out the pulley bearing. A good technique is to go around in a circle and lift from underneath the bearing in a carving motion.
    • Use one finger to pull out the pulley bearing.

    • A good technique is to go around in a circle and lift from underneath the bearing in a carving motion.

  7. Place the new pulley bearing inside the gear hole and use two fingers to push down evenly until it slides into place. The bearing should be flush with the gear The bearing should be flush with the gear
    • Place the new pulley bearing inside the gear hole and use two fingers to push down evenly until it slides into place.

    • The bearing should be flush with the gear

終わりに

To reassemble your device, follow these instructions in reverse order.

Emily Imfeld

メンバー登録日: 2016年10月06日

514 Reputation

4のガイドは作成済み

Team

Cal Poly, Team 15-7, Livingston Fall 2016 Cal Poly, Team 15-7, Livingston Fall 2016人のメンバー

CPSU-LIVINGSTON-F16S15G7

4 メンバー

6のガイドは作成済み

One Comment

you mentioned cleaning bearings how do you go about that? (if rep[lacing not an option at moment) Also I noticed a single Large Bearing in my replacement kit, what is that and where do I replace it as I don’t see where it could be (I have a first Gen)

Rick Gram - 返信

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 13

All Time: 1,053