Blu Studio HD 6.0 Midframe Replacement

はじめに

In this guide you'll be opening the battery housing of your Blu Studio, this is the second step you'll take whenever you replace or add internal parts (excluding the SIMs and SD cards).

Either fingernails or plastic prying tools can be used for lifting once all the screws have been removed.

必要な工具と部品

手順1 Rear Case

Blu Studio HD 6.0 Midframe Replacement, Rear Case: 手順 1、 1の画像 1

Begin by making sure your Blu Studio is turned off.

編集

手順2 Back Panel.

Blu Studio HD 6.0 Midframe Replacement, Back Panel.: 手順 2、 2の画像 1

Blu Studio HD 6.0 Midframe Replacement, Back Panel.: 手順 2、 2の画像 2

To begin the removal of your back panel, first locate the lift tab on the bottom-right corner.

編集

手順3

Next, gently slide your thumb (or plastic tool if you prefer) down the seem running the length of your Blu Studio until the rear panel is completely removed.
Your rear panel should be placed nearby and in a safe location until you are finished with your task.

編集

手順4 Midframe

Blu Studio HD 6.0 Midframe Replacement, Midframe: 手順 4、 2の画像 1

Blu Studio HD 6.0 Midframe Replacement, Midframe: 手順 4、 2の画像 2

With your back panel already removed from the previous guide you'll need to acquire a Philips head screw driver size (PH00)

編集

手順5

Next proceed to remove all 16 screws (2.5mm in length), all screws are the same size so getting them mixed up will not be an issue later on.
One of the lower right hand screws will be hidden under a sticker.

編集

手順6

After removing all 16 screws you can begin the process of removing the battery housing panel.
You will need to use the thinner plastic prying tool to slowly outline the seem of the case starting from the top (near the camera).
Try to be careful around the side buttons as the plastic is weakest there.
After the top half of the case has been opened insert the thicker prying tool to keep the case open. This will help as the battery and battery housing have a suction cup like action that keeps them from separating.