はじめに

Use this repair guide to install the screen in the Blackberry Pearl 8100

パーツ

パーツは必要ありません。

Before working on the phone, be sure that the phone is turned off. Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.
  • Before working on the phone, be sure that the phone is turned off.

  • Begin by removing the back panel; this can be done by pressing the silver button on the backside of the Blackberry 8100, while simultaneously sliding the back panel off.

コメントを追加する

  • Remove the battery located directly below back panel.

コメントを追加する

Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.
  • Using a 1.5 mm Hex screwdriver, remove the two screws that hold the two panels together.

コメントを追加する

Using the spudger, pry off the small portion of the casing located at the bottom of the phone. Using the spudger, pry off the small portion of the casing located at the bottom of the phone.
  • Using the spudger, pry off the small portion of the casing located at the bottom of the phone.

コメントを追加する

Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.
  • Using the spudger, pry off the side casings one at a time by wedging it between the inner casing and the sides.

コメントを追加する

Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.
  • Using a 1.5mm Hex screwdriver, unscrew the two screws, located on the front of the phone, that connect the back and front panels.

コメントを追加する

Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face.  Remove the back body panel. Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face.  Remove the back body panel.
  • Using the spudger, pry off the back body panel by wedging the spudger in between the front and back panels on the side face. Remove the back body panel.

コメントを追加する

Separate the logic board from the front panel.
  • Separate the logic board from the front panel.

コメントを追加する

Gently remove the keyboard from front casing. It should snap out of place. Gently remove the keyboard from front casing. It should snap out of place.
  • Gently remove the keyboard from front casing. It should snap out of place.

コメントを追加する

After removing the logic board, place spudger between the logic board and screen and remove the screen, sliding it slowly away.
  • After removing the logic board, place spudger between the logic board and screen and remove the screen, sliding it slowly away.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Robert Cronin

メンバー登録日: 2010年04月08日

520 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 34-57, Forte Spring 2010 Cal Poly, Team 34-57, Forte Spring 2010人のメンバー

CPSU-FORTE-S10S34G57

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 2

今までの合計 2,707