修理を始めるには コミュニティ ストア

Black and Decker WP900 Power Switch Replacement

はじめに

This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to the point where the on/off switch can be fully removed and replaced.

必要な工具と部品

  1. Black and Decker WP900 Power Switch Replacement, Power Switch: 手順 1、 1の画像 1

    • Using the plastic tool, detach the handle tab as shown.

    • Make sure the device is unplugged.

    編集

  2. Black and Decker WP900 Power Switch Replacement: 手順 2、 1の画像 1

    • Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.

    • Be sure to keep track of where each screw was placed in the device for later reassembly.

    編集

  3. Black and Decker WP900 Power Switch Replacement: 手順 3、 3の画像 1 Black and Decker WP900 Power Switch Replacement: 手順 3、 3の画像 2 Black and Decker WP900 Power Switch Replacement: 手順 3、 3の画像 3

    • Remove the back panel of the external casing, leaving all internal components resting in the front panel.

    • Remove the black handle from the main external casing.

    編集

  5. Black and Decker WP900 Power Switch Replacement: 手順 4、 1の画像 1

    • Loosen the power cord and control panel. Using the Phillip's #1 screwdriver, remove two 22mm screws.

    • The metal bracket will detach with the two screws.

    • Using the Flathead 3/32" screwdriver, remove two 22mm screws.

    編集

  6. Black and Decker WP900 Power Switch Replacement: 手順 5、 2の画像 1 Black and Decker WP900 Power Switch Replacement: 手順 5、 2の画像 2

    • Gently pull the power cord out from the control module.

    • Remember, when reassembling the device, the black wire should be on the top

    編集

  7. Black and Decker WP900 Power Switch Replacement: 手順 6、 1の画像 1

    • Firmly grasping the motor, dislodge the internal components from the frontal external casing.

    • Switch and control panel will be attached to magnet body.

    編集

  8. Black and Decker WP900 Power Switch Replacement: 手順 7、 1の画像 1

    • Remove the switch from the wires.

    • Gently, pull and release the two wired connections.

    • The switch can now be replaced. Be sure not to damage the two connections to the control module in the process.

    編集
終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

Cameron

メンバー登録日: 02/15/16

231 ポイント

2のガイドは作成済み

バッジ: 12

+9 個以上のバッジ

チーム

IUPUI, Team 8-8, Wilson Spring 2016 IUPUI, Team 8-8, Wilson Spring 2016人のメンバー

IUPUI-WILSON-S16S8G8

4 メンバー

4のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 8

過去 30 日: 10

今までの合計 983