Black and Decker WP900 Power Cord Replacement - iFixit 修理ガイド

はじめに

This page gives instructions for disassembling the Black and Decker WP900 6-Inch Orbital Waxer and Polisher to the point where the power cable can be fully removed and replaced.

必要な工具と部品

手順1 Power Cord

Black and Decker WP900 Power Cord Replacement, Power Cord: 手順 1、 1の画像 1

Using the plastic tool, detach the handle tab as shown.
Make sure the device is unplugged.

手順2

Black and Decker WP900 Power Cord Replacement: 手順 2、 1の画像 1

Using the Philips #1 screwdriver, unscrew all of the screws. There should be 8-30mm screws to remove.
Be sure to keep track of where each screw was placed in the device for later reassembly.

手順3

Black and Decker WP900 Power Cord Replacement: 手順 3、 3の画像 1

Black and Decker WP900 Power Cord Replacement: 手順 3、 3の画像 2

Black and Decker WP900 Power Cord Replacement: 手順 3、 3の画像 3

Remove the back panel of the external casing, leaving all internal components resting in the front panel.
Remove the black handle from the main external casing.

手順4

Black and Decker WP900 Power Cord Replacement: 手順 4、 1の画像 1

Loosen the power cord and control panel. Using the Phillips #1 screwdriver, remove two 22mm screws.
The metal bracket will detach with the two screws.
Using the Flathead 3/32" screwdriver, remove two 22mm screws.

手順5

Black and Decker WP900 Power Cord Replacement: 手順 5、 2の画像 1

Black and Decker WP900 Power Cord Replacement: 手順 5、 2の画像 2

Gently pull the power cord out from the control module.
This is the part to be replaced. Remember to insert the black wire into the top port when installing the new cord.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

1人の作成者と共同作成されました。

Cameron

メンバー登録日: 02/15/16

231 ポイント

2のガイドは作成済み

+9 個以上のバッジ

チーム

IUPUI, Team 8-8, Wilson Spring 2016 IUPUI, Team 8-8, Wilson Spring 2016人のメンバー

IUPUI-WILSON-S16S8G8

4 メンバー

4のガイドは作成済み

0 件のコメント

統計データ:

過去 24時間: 1

過去 7 日: 4

過去 30 日: 8

今までの合計 276