-
-
Make sure that the toaster is unplugged before you begin.
-
Turn the toaster over with its backside face down.
-
Remove the two Phillips #4 1cm screws that attach the side panels.
-
-
-
-
-
-
-
-
Remove the knobs by pulling them upward; they should slide right off.
-
When placing the knobs back on the unit, make sure the semicircle notch fits correctly in the hole so that the knobs don't fall off.
-
-
Unhook the bottom of the the display panel from the toaster unit.
-
It will be a little tough to pry off, but don't be afraid to be forceful. You can use your hands, or pliers, to bend the metal piece backwards.
-
-
Begin to detach the back panel from the toaster unit.
-
Then, unhook the rest of the display panel.
-
This will also be a little tough to get off, but don't be afraid to be forceful.
-
-
-
-
-
-
Use the screwdriver to remove the spring from the unit.
-
Place the screwdriver inside the spring loop.
-
Pull to unhinge the spring from the back panel.
-
-
Remove the spring from the door mechanism by pulling it off.
-
Replace the old spring with a new spring.
-
When inserting a new spring, make sure that the spring is connected to the lower hole of the back panel (the hole above is used for the back casing).
このガイドを埋め込む
サイズを選択し、以下のコードをコピーして、このガイドを小さなウィジェットとしてサイト/フォーラムに埋め込みます。
プレビュー