はじめに

The pivot button may need to be installed if problems such as jamming of the button occur. This guide will outline how to install the pivot button on the Black and Decker Pivot Plus PD600.

パーツ

パーツは必要ありません。

Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver. Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver.
  • Remove the screw located on the opposite side of the black half of the button with the lock symbol with the Phillips #1 screwdriver.

コメントを追加する

After the screw is removed, take off both sides of the button. You will be left with 3 pieces. Two halves of the button (a black piece with a lock on the front, and a circular orange piece) will be left over along with a spring.
  • After the screw is removed, take off both sides of the button.

  • You will be left with 3 pieces. Two halves of the button (a black piece with a lock on the front, and a circular orange piece) will be left over along with a spring.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Ryan Angelich

メンバー登録日: 2013年05月13日

101 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 4-15, Maness Spring 2013 Cal Poly, Team 4-15, Maness Spring 2013人のメンバー

CPSU-MANESS-S13S4G15

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 2

過去 30 日: 8

今までの合計 705