メインコンテンツにスキップ

はじめに

This guide will take you through the process of replacing the switch on the Black and Decker BV2500 Type 4.

パーツ

パーツは指定されていません。

  1. Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).
    • Using a Phillips #2 screwdriver, remove the six 20 mm screws in the black plastic casing (clamshell).

  2. Using your hands, remove the blower tube and clamshell. To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.
    • Using your hands, remove the blower tube and clamshell.

    • To remove the clamshell, pull apart starting from the bottom until it is pulled out from the notches. Then slide it out away from the device.

  3. Locate and unscrew the ten 20 mm Phillips #2 screws in the orange casing with a Phillips #2 screwdriver. Using your hands, lift off side of the orange casing with the screws facing you.
    • Locate and unscrew the ten 20 mm Phillips #2 screws in the orange casing with a Phillips #2 screwdriver.

    • Using your hands, lift off side of the orange casing with the screws facing you.

  4. Locate the switch on the handle of the blower. Carefully remove the four wires that are attached to the switch.
    • Locate the switch on the handle of the blower.

    • Carefully remove the four wires that are attached to the switch.

    • Use your hand to push in the sides of the switch and slide out the wires.

終わりに

To reassemble your device, follow these instructions in reverse order.

Jon Gori

メンバー登録日: 2014年01月25日

126 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 9-29, Maness Winter 2014 Cal Poly, Team 9-29, Maness Winter 2014人のメンバー

CPSU-MANESS-W14S9G29

4 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 1

過去 7 日: 9

過去 30 日: 35

今までの合計 1,336