メインコンテンツにスキップ

Black and Decker BL3000S Circuit Board

必要な工具と部品

  1. Black and Decker BL3000S Circuit Board, Blender Base: 手順 1、 2の画像 1 Black and Decker BL3000S Circuit Board, Blender Base: 手順 1、 2の画像 2
    • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

    • Lift the jar straight up from the base without tilting the jar.

  2. Black and Decker BL3000S Circuit Board: 手順 2、 1の画像 1
    • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

  3. Black and Decker BL3000S Circuit Board: 手順 3、 2の画像 1 Black and Decker BL3000S Circuit Board: 手順 3、 2の画像 2
    • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

    • This provides access to the base screws beneath.

  4. Black and Decker BL3000S Circuit Board: 手順 4、 1の画像 1
    • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

    • Both screwdrivers must have a minimum of a three inch shank (length).

    • Screwdrivers with extenders will not fit down the access holes.

  5. Black and Decker BL3000S Circuit Board: 手順 5、 1の画像 1
    • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

  6. Black and Decker BL3000S Circuit Board, Circuit Board: 手順 6、 1の画像 1
    • Once you have the base removed, the circuit board should be clearly visible inside.

  7. Black and Decker BL3000S Circuit Board: 手順 7、 2の画像 1 Black and Decker BL3000S Circuit Board: 手順 7、 2の画像 2
    • Remove the four screws located on the circuit board.

    • Two are on the left side.

    • Two are on the right side.

  8. Black and Decker BL3000S Circuit Board: 手順 8、 1の画像 1
    • Remove the following soldered connections with a soldering iron:

    • Motor wires

    • Power cord wires

  9. Black and Decker BL3000S Circuit Board: 手順 9、 1の画像 1
    • Lift the circuit board straight up to remove it from the base.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

作成者

4人の作成者と共同で作成されました。

Andrew

メンバー登録日: 10/04/12

209 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 6-34, Regan Fall 2012 Cal Poly, Team 6-34, Regan Fall 2012人のメンバー

CPSU-REGAN-F12S6G34

4 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 5

過去 7 日: 12

過去 30 日: 31

今までの合計 4,650