Bell and Howell DNV16HDZ LED Replacement

はじめに

In this guide, the goal is to show how to take apart a Bell and Howell DNV16HDZ camcorder in order to replace parts such as the front LED. This would be helpful in the case of a damaged or malfunctioning LED in the camcorder. In this repair guide every screw was taken out using the Philips head #0 driver which is quite small. Also every screw taken out is the same uniform size (2mm) which is quite convenient.

必要な工具と部品

手順1 Lens Assembly

Bell and Howell DNV16HDZ LED Replacement, Lens Assembly: 手順 1、 2の画像 1

Bell and Howell DNV16HDZ LED Replacement, Lens Assembly: 手順 1、 2の画像 2

Remove the five 30mm Phillips #0 screws on the bottom of the camera.

編集

手順2

Use a plastic opening tool to disconnect the internal hinges that snaps the camera into place.
Using a plastic opening tool is important since a metal one will scratch or damage the thin plastic hinges that hold the camera together.

編集

手順3

It will still be connected by a plastic film. This can also be disconnected by pulling up the white part where it connects to the light circuit board.

編集

手順4 LED

Bell and Howell DNV16HDZ LED Replacement, LED: 手順 4、 1の画像 1

Take out the two 20 mm Phillips #0 screws that attach it to the shutter.

編集

手順5

Bell and Howell DNV16HDZ LED Replacement: 手順 5、 3の画像 3

The two 30 mm Phillips #0 screws left can be removed to gain access to the circuit board along with the LED.
From here we can pop out the LED using the wedge or your fingers if you can manage it.

編集