Atmega328P Microcontroller Replacement for Arduino Board

はじめに

This is a guide on how to replace a ATMega328P microcontroller (Code: X000048) on an Arduino UNO R3 Board (Model: EL-CB-001, Code: A000066). This guide does not require any specialized skills or knowledge.

The ATMega328P processes the instructions in C from the Arduino IDE. If damaged, the code cannot be executed. Fortunately, replacing the microcontroller is a simple and uncomplicated process. Before starting the repair, please unplug the the Arduino board from the USB.

必要な工具と部品

手順1 Atmega328P Microcontroller

Atmega328P Microcontroller Replacement for Arduino Board, Atmega328P Microcontroller: 手順 1、 1の画像 1

Place the Arduino UNO R3 board on a flat clean surface.

編集

手順2

On the right side of board, position a nylon spudger in between the microcontroller and the dip socket, and gently lift upwards to pry it out.
The bottom of the microcontroller can be scratched if not done carefully. Do not use a metal tool for this step.

編集

手順3

Repeat the same process on the other side.
Lift both sides evenly to prevent any damage to the pins.

編集

手順4

Atmega328P Microcontroller Replacement for Arduino Board: 手順 4、 3の画像 3

Repeat steps 2 and 3 until the microcontroller is loose enough to remove out of the socket.

編集

手順5

Remove replacement microcontroller out of packaging.

編集

手順6

If needed, straighten the pins of the replacement microcontroller and place it directly over the dip socket.
Make sure the notch on the side of the microcontroller is facing the right, matching the white lines on the board.

編集