1. Flip the computer over so that it is upside down.
    • Flip the computer over so that it is upside down.

    • Slide both latches away from each other (towards the outside).

    • Push the battery out with your fingers.

    • The actual battery is not shown in the photograph.

  2. On the back panel unscrew highlighted screws and carefully put them to the side as not to lose them.
    • On the back panel unscrew highlighted screws and carefully put them to the side as not to lose them.

    • Locate the RAM chip highlighted in Blue and the two metal tabs holding it in place highlighted in red.

    • Carefully use your thumbs to push out the metal tabs and the RAM should spring up.

    • After the ram has sprung up, carefully grab the edges with your fingers and gently pull straight out.

    • After you have gotten either more RAM or replacement RAM line up the pins and slot (highlighted red) in the RAM card with the pin on the computer.

    • Carefully insert the new ram in at the same angle that you removed it at.

    • The other side of the RAM slot is a place for more RAM if you want to put more in. The spaces are highlighted in blue.

まとめ

To reassemble your device, follow these instructions in reverse order.

Connor

メンバー登録日: 2010年06月24日

34 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 2-9, Johann Summer 2010 Cal Poly, Team 2-9, Johann Summer 2010人のメンバー

CPSU-JOHANN-R10S2G9

5 メンバー

10のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 3,213