はじめに

All the buttons on the tablet are located in one corner. They are all controlled by a button module board, which can be removed if desired.

パーツ

パーツは必要ありません。

  1. Separate the tablet from the base by pressing the large silver button below the tablet. The silver button is located at the base of the tablet.
    • Separate the tablet from the base by pressing the large silver button below the tablet. The silver button is located at the base of the tablet.

    • Remove the tablet by lifting up.

    コメントを追加する

  2. Insert the opening tool into the seam of the tablet casing and gently pry upwards.
    • Insert the opening tool into the seam of the tablet casing and gently pry upwards.

    • With a little force, you will feel the clips release.

    This image seems not to show the correct position where to place the tip of the tool initially. It suggests to pry between the frame and the glass pane from the top of the tablet. That's what I did and broke the glass - one device spoilt. Only the next picture correctly shows where to apply the tool.

    Ole Hoppe - 返信

    • Slide the tool along all four edges of the tablet, making sure that all the clips are released.

    • Do not break these clips; otherwise, the screen will become less secure.

    コメントを追加する

    • Remove the rear casing.

    コメントを追加する

    • Unclip the white connection clip using a pair of tweezers.

    コメントを追加する

    • Pull the connection apparatus from the connection clip on the board using a pair of tweezers.

    コメントを追加する

    • Gently fold the connection apparatus back away from your work area.

    コメントを追加する

    • Remove the screws using a Phillips Head #1 screwdriver.

    • Remove the power button module.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Taylor Pantiga

メンバー登録日: 2014年04月14日

1,277 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 13-31, Maness Spring 2014 Cal Poly, Team 13-31, Maness Spring 2014人のメンバー

CPSU-MANESS-S14S13G31

3 メンバー

6のガイドは作成済み

コメント1件

My problem is that when reinstalltng the back cover the button does not fit the button module to press the on/off switch. The switch works allright.

What can i do? At this moment I can only switch the tablet on after removing the back cover.

Rudolf Guys - 返信

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 11

過去 30 日: 44

今までの合計 4,605