Asus MeMO Pad 7 ME170C Front Facing Camera Replacement

はじめに

The front facing camera is used to take photos from the tablets front orientation. The camera may stop taking photos and videos clearly. This can be replace fairly easily, but the motherboard needs to be removed first.

必要な工具と部品

手順1 Motherboard

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement, Motherboard: 手順 1、 3の画像 1

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement, Motherboard: 手順 1、 3の画像 2

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement, Motherboard: 手順 1、 3の画像 3

Power off the device before disassembly.
Be gentle; excessive force can result in a damaged or cracked screen.
Gently pry a Jimmy all around the seam of the device until the back panel detaches.

編集

手順2

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement: 手順 2、 3の画像 3

Use an iFixit opening tool to gently push the black bundle cable connector in a forward motion until it loosens without pushing down on the bundle cable connector.

編集

手順3

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement: 手順 3、 3の画像 3

Use the plastic opening tool to pry around the edges of the battery.
The battery should be laying freely in its port.
Lift the battery out of its port.

編集

手順4

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement: 手順 4、 3の画像 3

Use a plastic opening tool to slide the white cable connector completely out of the port.

編集

手順5

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement: 手順 5、 3の画像 3

Flip up the beige clip to loosen the cable.
Use the wide nosed tweezers to pinch the blue tab attached to the ribbon cable.
Pull the blue tab gently in a lateral motion until it is completely out of its port.

編集

手順6

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement: 手順 6、 3の画像 3

Use the wide nosed tweezers to gently pull out the orange ribbon inserted in the port on the motherboard.

編集

手順7

Asus MeMO Pad 7 ME170C Front Facing Camera Replacement: 手順 7、 3の画像 3

Use a plastic opening tool to push the white cable connector out of its port in a side to side motion.

編集

手順8

Use the Phillips #000 screwdriver to unscrew the seven screws.
There should be two silver and five black screws.

編集

手順9

Once the screws are removed, the speaker component will be loosely laying in the track.
Use the metal spudger tool to remove the speaker by gently lifting the edge of it.

編集