メインコンテンツにスキップ

この修理ガイドは変更されています。最新の未承認バージョンに切り替えます。

Anker 2.4G Wireless Mouse Sensor Replacement

必要な工具と部品

  1. Anker 2.4G Wireless Mouse Sensor Replacement, Sensor: 手順 1、 1の画像 1
    • Use the screwdriver to pry off the stickers marked in red to reveal the location of 4 screws.

  2. Anker 2.4G Wireless Mouse Sensor Replacement: 手順 2、 1の画像 1
    • Remove the 4 screws marked in red.

  3. Anker 2.4G Wireless Mouse Sensor Replacement: 手順 3、 2の画像 1 Anker 2.4G Wireless Mouse Sensor Replacement: 手順 3、 2の画像 2
    • Use a flat head screw driver to pry apart the upper and lower housing of the mouse.

  4. Anker 2.4G Wireless Mouse Sensor Replacement: 手順 4、 1の画像 1
    • Pull the wires from the white crimping headers to disconnect them, separating the top from bottom.

    • Pull as far up on the wire as possible, but be careful to avoid ripping the wires.

  5. Anker 2.4G Wireless Mouse Sensor Replacement: 手順 5、 1の画像 1
    • Remove the scroll wheel from the mother board by pulling it to the left.

    • This may take some force to remove. Make sure to pull it parallel to the board, instead of perpendicularly.

  6. Anker 2.4G Wireless Mouse Sensor Replacement: 手順 6、 1の画像 1
    • Pull the mother board gently away from the plastic housing.

  7. Anker 2.4G Wireless Mouse Sensor Replacement: 手順 7、 2の画像 1 Anker 2.4G Wireless Mouse Sensor Replacement: 手順 7、 2の画像 2
    • The IC (Integrated Circuit) is highlighted in red, it is the mouse sensor.

    • Desolder the 6 wires holding the IC in place to complete the sensor change.

    • Replace component with new component and resolder back in place.

終わりに

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

作成者

12人の作成者と共同で作成されました。

Ryan

メンバー登録日: 01/23/14

140 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 1-39, Maness Winter 2014 Cal Poly, Team 1-39, Maness Winter 2014人のメンバー

CPSU-MANESS-W14S1G39

4 メンバー

16のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 20

今までの合計 7,487