Altec Lansing Mini Lifejacket 2 Speaker Replacement

はじめに

If your Altec Lansing Mini Lifejacket 2's speaker is damaged or faulty, use the following step-by-step guide to replace it. This guide applies to both the speakers.

必要な工具と部品

手順1 Back Panel

Altec Lansing Mini Lifejacket 2 Speaker Replacement, Back Panel: 手順 1、 3の画像 1

Altec Lansing Mini Lifejacket 2 Speaker Replacement, Back Panel: 手順 1、 3の画像 2

Altec Lansing Mini Lifejacket 2 Speaker Replacement, Back Panel: 手順 1、 3の画像 3

Use the spudger to remove the eight black pins from the front and back of the wire screens.

編集

手順2

Altec Lansing Mini Lifejacket 2 Speaker Replacement: 手順 2、 3の画像 3

Detach the eight secondary pins from the front and back of the wire mesh plates with a spudger.
Removing the secondary pins from the rubber casing is optional.

編集

手順3

Remove both black and orange layers from the speaker body.

編集

手順4

Altec Lansing Mini Lifejacket 2 Speaker Replacement: 手順 4、 3の画像 3

Remove the single 7.8mm Phillips #2 screw from the mounting plate located under the device.
Slide the mounting plate out to remove it.

編集

手順5

Pry off the wire mesh on both sides using a metal spudger.
Be gentle to avoid bending the mesh.

編集

手順6

この手順で使用する道具：

Tweezers

$4.99

購入する

Using tweezers, remove the four rubber stoppers in each corner of the rear panel.

編集

手順7

Remove the four 13.7mm Phillips #1 screws located underneath the rubber stoppers.

編集

手順8

Pull the case apart to access the interior components.

編集

手順9

Altec Lansing Mini Lifejacket 2 Speaker Replacement: 手順 9、 3の画像 3

To remove the back panel, gently pull out its wire harness.

編集

手順10 Speaker

Altec Lansing Mini Lifejacket 2 Speaker Replacement, Speaker: 手順 10、 2の画像 1

Altec Lansing Mini Lifejacket 2 Speaker Replacement, Speaker: 手順 10、 2の画像 2

Remove the three 9.3 mm Phillips #1 screws on the speaker cover.

編集

手順11

Altec Lansing Mini Lifejacket 2 Speaker Replacement: 手順 11、 3の画像 3

To remove the speaker, gently pull out the its wire harness.

編集

手順12

Remove the rubber ring from the rim of the speaker.
This ring helps keep water from entering the device. Be careful to position it correctly during reassembly.

編集