はじめに

Electrolytic capacitors are electronic components used to store energy. If too much current runs through a capacitor, it may become bulged and need to be replaced. To replace a capacitor on the MRV-M500 you will need previous experience soldering electronics. To learn how to solder, see this guide.

  1. Remove all the Phillips 10.0mm and 7.0mm screws on the outside of the case.
    • Remove all the Phillips 10.0mm and 7.0mm screws on the outside of the case.

    • Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.

    コメントを追加する

  2. Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case.
    • Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case.

    • Remove the circuit board from the case.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • Find the faulty capacitor.

    • Flip the board over and locate the corresponding pins.

    • If the faulty capacitor is one of the smaller ones, it may be too difficult to replace and replacing the circuit board itself may be easier.

    • Make sure that the capacitance and voltage rating of the new capacitor match that of the original.

    コメントを追加する

    • Desolder the pins to remove the capacitor.

    • Solder the new capacitor into its place.

    • Make sure the polarity of the new capacitor matches the previous polarity.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Eric Gaulke

メンバー登録日: 2018年09月17日

407 ポイント

3のガイドは作成済み

チーム

Washington State, Team S2-G6, Hope Fall 2018 Washington State, Team S2-G6, Hope Fall 2018人のメンバー

WSU-HOPE-F18S2G6

4 メンバー

3のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 5

過去 30 日: 16

今までの合計 33