Skip to main content

はじめに

If your laptop overheats, you must open it, clean the cooling system and replace the CPU thermal paste.

ビデオの概要

  1. Switch-off the Laptop. Remove 17x Philips screws.
    • Switch-off the Laptop.

    • Remove 17x Philips screws.

  2. Start opening from the SD Memory Card hole Use plastic tools to avoid damaging the cover. Use plastic tools to avoid damaging the cover.
    • Start opening from the SD Memory Card hole

    • Use plastic tools to avoid damaging the cover.

  3. Before doing anything, disconnect the battery.
    • Before doing anything, disconnect the battery.

  4. MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now

    MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now
  5. Disconnect the Fan cable. Remove the three screws from the CPU cooler and one from the Fan module.
    • Disconnect the Fan cable.

    • Remove the three screws from the CPU cooler and one from the Fan module.

    • When you change the Cooling system, you must clean the processor from old thermal compound and put new.

  6. Use a lint-free cloth to clean the old thermal compound. If the thermal compound is solidified, you can use a flat end of any plastic tool to scrape it off. Use again cloth with isopropyl alcohol to clean the Thermal surface.
    • Use a lint-free cloth to clean the old thermal compound.

    • If the thermal compound is solidified, you can use a flat end of any plastic tool to scrape it off.

    • Use again cloth with isopropyl alcohol to clean the Thermal surface.

  7. Remove the 3x Phillips screws and open the Fan case. Use a soft brush and clean the Fan and the Cooler. Use a soft brush and clean the Fan and the Cooler.
    • Remove the 3x Phillips screws and open the Fan case.

    • Use a soft brush and clean the Fan and the Cooler.

  8. Use the same technic to clean the surface of the processor from the old thermal compound Be carefully,if you don't want to break the CPU. Dispense a small amount of thermal compound and gently smear it over the entire processor surface.
    • Use the same technic to clean the surface of the processor from the old thermal compound

    • Be carefully,if you don't want to break the CPU.

    • Dispense a small amount of thermal compound and gently smear it over the entire processor surface.

  9. Careful install the Cooling system with even pressure from all sides, and the bead that you placed on the surface will spread over the entire contact surface. Careful install the Cooling system with even pressure from all sides, and the bead that you placed on the surface will spread over the entire contact surface.
    • Careful install the Cooling system with even pressure from all sides, and the bead that you placed on the surface will spread over the entire contact surface.

まとめ

To reassemble your device, follow these instructions in reverse order.

ZFix

メンバー登録日: 2013年12月09日

164,056 ポイント

305のガイドは作成済み

チーム

Master Techs Master Techs人のメンバー

Community

286 メンバー

808のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 7

過去 30 日: 24

今までの合計 1,966