メインコンテンツにスキップ

はじめに

Hard drives store all your data, but they are slow and can fail. This guide will show you how to replace a broken or slow hard drive with a different hard drive or solid state drive.

  1. Unscrew the single (5mm) Philips head screw holding the drive in place.
    • Unscrew the single (5mm) Philips head screw holding the drive in place.

  2. Pull out the optical drive.
    • Pull out the optical drive.

  3. Unscrew all 17 (5mm) Philips head screws from the bottom. Unscrew the 3 (2.5mm) Philips head screws underneath the optical drive.
    • Unscrew all 17 (5mm) Philips head screws from the bottom.

    • Unscrew the 3 (2.5mm) Philips head screws underneath the optical drive.

  4. Run a pick around the edge of the laptop (between the two parts) to open it. Lift the left side of the case up and unplug the speaker cable before fully taking the bottom off.
    • Run a pick around the edge of the laptop (between the two parts) to open it.

    • Lift the left side of the case up and unplug the speaker cable before fully taking the bottom off.

  5. Remove the hard drive by pulling it out to the left.
    • Remove the hard drive by pulling it out to the left.

まとめ

To reassemble your device, follow these instructions in reverse order.

2 の人々がこのガイドを完成させました。

Alex Bahm

メンバー登録日: 2018年01月18日

1,514 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team S12-G5, Banghart Winter 2018 Cal Poly, Team S12-G5, Banghart Winter 2018人のメンバー

CPSU-BANGHART-W18S12G5

3 メンバー

13のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 8

過去 7 日: 41

過去 30 日: 156

今までの合計 2,403